2007 August 16: :
Created:
Updated:
First entry|Previous entry|Next entry|Last entry
Cleaned the u-joint, driveshaft and coupler, swing arm pivot pins and locknuts. Installed the u-joint into the swing arm, slipped on the boot and attempted to install the swing arm into the frame. Attempted, because the swing arm was hitting the shift linkage. Needed a straight shift lever for clearance and since I didn't have one, installed the stock linkage with clevis and pins instead of the ball-end joints. Once that was taken care of, the swing arm went in with no further problems.
Photo courtesy of Charlie Mullendore of Antietam Classic Cycle.